 |
 |
 |
|
|
|
[Sponsors] | ||||
October 21, 2011, 09:16
|
porousBafflePressure BC condition
|
#1 |
|
New Member
diego peinado martin
Join Date: Oct 2009
Posts: 1
Rep Power: 0  |
Hello, I'm new to OpenFOAM. I'm trying to model a pressure drop caused by a filter media in one duct. I've defined a rectangular channel. In the middle I used topoSet and createBaffles, so I have a cyclic patch inside the fluid domain. As it is a one phase incompressible flow, I've tried to use porousSimpleFoam as solver, but this BC is not recognized by this solver.
The question is, do I have to run the interFoam solver if I want to use a porousBafflePressure BC? And a secondary question is, how to indentify which of all the derivedFvPatches can be used with each solver? Thanks in advance, best regards, |
|
|
|
|
 |
| Tags |
| openfoam, porous media, porousbafflepressure |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| External Radiation Boundary Condition (Two sided wall), Grid Interface | CFD XUE | FLUENT | 0 | July 8, 2010 06:49 |
| vorticity boundary condition | bearcharge | Main CFD Forum | 0 | May 14, 2010 11:32 |
| Airfoil boundary condition | Frank | Main CFD Forum | 1 | April 21, 2008 18:36 |
| Slip boundary condition what is inside | normunds | OpenFOAM Running, Solving & CFD | 2 | June 4, 2007 06:45 |
| The Boundary Condition about the Flat Plate | boing | Main CFD Forum | 1 | January 6, 2002 16:53 |
Linear Mode
