|
[Sponsors] |
January 8, 2012, 11:51 |
Problem with rhoSimplecFoam - nan
|
#1 |
Senior Member
Daniel
Join Date: Jul 2009
Location: Montreal, Canada
Posts: 156
Rep Power: 16 |
Hello all,
I am trying to evolve my incompressible, steady-state 2D airfoil simulation into a compressible, steady-state simulation. I have selected rhoSimplecFoam as a solver, however I cannot get the simulation to run past 9 iterations without getting "nan" for the residuals first with k and omega, then the next iteration has residuals of "nan" for all variables. I have tried playing with the boundary conditions and solver parameters to no avail. Would someone please suggest where I could start looking? Some information: 1. The simulation runs successfully and with results that compare well to experimental data in simpleFoam; 2. The mesh is a c-grid with ~42000 cells and a boundary 10c from the NACA 0012 airfoil; 3. Angle of attack is 13 degrees, implemented by introducing a inlet velocity at that angle (mesh pic attached); 4. Boundary conditions are as attached; 5. k-omega turbulence model; 6. fvSolution & fvSchemes copied from tutorial rhoSimplecFoam\squareBend. Thank you for any suggestions, Dan |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with interFoam; Wave/wiggle alpha1 behavior | JonW | OpenFOAM | 10 | February 4, 2023 08:27 |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 05:43 |
Problem in implementing cht | tilek | CFX | 3 | May 8, 2011 09:39 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 07:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 20:13 |