|February 16, 2012, 08:13||
boundary layer, how to do it?
Join Date: Jan 2012
Posts: 37Rep Power: 3
I was trying to set a turbulent boundary layer in OpenFoam.
The solver I am focused on is SIMPLEFOAM and the case observe is the pitzdaily. I want to set the boundary layer profile at the inlet and the let the solver solve the flow field in the computational field. The problem I have is about the Boundary condition and for the pressure p and for the Velocity U (i don't want to set a condition for the pressure, it must be computed by equations)...how is it possible to do it?
Obviously I have the library which allows me to insert a special profile at the inlet for the downstream direction...
thank you in advance to who will have the kindness and the patience to answer
Last edited by sawyer86; February 16, 2012 at 08:41.
|Thread||Thread Starter||Forum||Replies||Last Post|
|No layers in a small gap||bobburnquist||OpenFOAM Native Meshers: snappyHexMesh and Others||2||November 25, 2012 08:54|
|Grid Independence of Boundary layer||Luigi_||Main CFD Forum||0||December 14, 2011 13:42|
|Boundary Layer Question||scottneh||STAR-CCM+||3||September 30, 2010 14:21|
|3D Boundary Layer||Mario||FLUENT||0||February 17, 2009 03:40|
|Trimmed cell and embedded refinement mesh conversion issues||michele||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||2||July 15, 2005 04:15|