|April 16, 2014, 06:23||
spray-A and spray-H validation
Join Date: Nov 2013
Posts: 21Rep Power: 4
I would like to perform validation of spray-A and spray-H experiments performed by Sandia labs.
I would like to know how to find out the initial size distribution of the droplets to be injected.
Is this quantity measured or do I have to use primary break up models. If anyone has performed CFD validation of these experiments.
|April 16, 2014, 21:11||
Join Date: Jul 2009
Location: Amherst, MA USA - San Diego, CA USA
Posts: 320Rep Power: 10
You might want to take a look at some of the proceedings from the 2014 SAE world congress which was last week. There were many talks concerning modeling of the Sandia baseline sprays which might be relevant to you.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Spray total droplet momentum calculation help||tarnsharma||AVL FIRE||0||July 19, 2012 08:17|
|Spray slows then stops||coastal593||OpenFOAM Running, Solving & CFD||6||July 31, 2007 16:14|
|spray injection||mmacrb||FLUENT||0||January 10, 2007 05:57|
|Spray combustion validation||David||FLUENT||0||December 20, 2004 13:51|
|Gasoline spray code validation||Antonis||Main CFD Forum||0||December 1, 1998 11:19|