|
[Sponsors] |
May 24, 2016, 17:07 |
Thermosingle layer RegionModel
|
#1 |
Member
Zhiheng Wang
Join Date: Mar 2016
Posts: 72
Rep Power: 10 |
Hi EveryOne
I am getting folllowing error while running FireFOAM case with surfaceFilm modelling. --> FOAM FATAL ERROR: request for volScalarField deltaf from objectRegistry region0 failed available objects of type volScalarField are 45 ( d fres_O2 thermo:mu cp fres_CH3OH thermosi N2 ((ddt(p)+convection(phiU,p))-(div(phiU)*p)) h kappa fres_CO2 rho CO2 k (hc+h) O2 p_rgh muM gh delta thermosi_0 dSgs CH3OH flameHeight dQ wFuel rho_0 p T rhoFu QcWallFunction alphaM p_0 alphaSgs fres_N2 pSpf hc H2O fres_H2O rhoT rhoSpf hsSp muSgs thermo:alpha ft ) PLese HELP If you can |
|
June 1, 2016, 03:54 |
|
#2 | |
Member
Zhiheng Wang
Join Date: Mar 2016
Posts: 72
Rep Power: 10 |
Quote:
|
||
June 13, 2016, 11:35 |
Possibly the Wrong forum
|
#3 |
New Member
Christopher
Join Date: Jun 2013
Location: Gainesville, Florida
Posts: 11
Rep Power: 12 |
I believe you would have better luck posting this in a different forum because this particular one is for the validation and verification of the OpenFOAM code.
|
|
June 24, 2016, 03:11 |
|
#4 |
Member
Zhiheng Wang
Join Date: Mar 2016
Posts: 72
Rep Power: 10 |
I got results but i dont know how promising they are thanks by the way
|
|
August 1, 2019, 06:56 |
|
#5 |
Member
Join Date: Feb 2018
Posts: 91
Rep Power: 8 |
Hi Zhiheng,
Were you able to figure out the problem. i am trying to run fireFoam with surface film models and I don't think I am getting the right answer. I assume the fuel to be a surface film but am not getting any combustion |
|
November 16, 2019, 05:35 |
|
#6 |
Member
Atul Kumar
Join Date: Dec 2015
Location: National Centre for Combustion Research and Development
Posts: 48
Rep Power: 10 |
Hi Sorry for late reply,
What is the objective of modelling the surface-film , can you elaborate in detail. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] snappyHexMesh Boundary Layer at Corner | panpanzhong | OpenFOAM Meshing & Mesh Conversion | 5 | July 3, 2018 05:53 |
Prismatic boundary layer | KateEisenhower | enGrid | 5 | September 15, 2015 07:48 |
[snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |
[snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 13:47 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |