|
[Sponsors] |
[waves2Foam] Ask about the number of points used in the probes |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 20, 2016, 11:03 |
Ask about the number of points used in the probes
|
#1 |
Member
Xiantao Zhang
Join Date: Nov 2014
Posts: 31
Rep Power: 11 |
Hi all,
For regular waves, the wave height is H. I set the lower end of the probe at -H from still water level and the upper end of the probe at +H from the still water level. And the default number of points of a probe is 100. So in this case the length of the probe is quite small and the number of points is relatively large. Does this affect the accuracy of the surface elevation??? Hope to receive any advice or comments. Many thanks Xiantao |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Foam::error::PrintStack | almir | OpenFOAM Running, Solving & CFD | 91 | December 21, 2022 04:50 |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
simpleFoam parallel | AndrewMortimer | OpenFOAM Running, Solving & CFD | 12 | August 7, 2015 18:45 |
decomposePar pointfield | flying | OpenFOAM Running, Solving & CFD | 28 | December 30, 2013 15:05 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |