Import solution from a Fluent simulation

samiam1000 · September 17, 2012, 09:40

Dear Foamers,

I have a steady solution obtained with Fluent and I would like to know if it is impossible to import it, in order to use it as initial solution for an unsteady simulation with OF.

Of course, the mesh is the same.

Thanks a lot for help.

Samuele

olivierG · September 18, 2012, 04:01

hello,

There is a tool in the 1.6-ext called "fluentDataToFoam" which should do the job.
So you need to try the 1.6-ext version, or try to copy & compile in your 2.1 version.

regards,
olivier

samiam1000 · September 18, 2012, 04:44

Thanks a lot.

I tryed to compile it, but it does not work.

I'll work on it.

Thanks a lot,

Samuele

September 17, 2012, 09:40	Import solution from a Fluent simulation	#1
samiam1000 Senior Member Samuele Z Join Date: Oct 2009 Location: Mozzate - Co - Italy Posts: 520 Rep Power: 18	Dear Foamers, I have a steady solution obtained with Fluent and I would like to know if it is impossible to import it, in order to use it as initial solution for an unsteady simulation with OF. Of course, the mesh is the same. Thanks a lot for help. Samuele

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fluent exceeding Solution Limits on faces	bawfuls	FLUENT	3	July 10, 2012 16:34
I hope you can point out problems in my FLUENT solution	tp9180188	FLUENT	2	March 15, 2012 11:40
Chemical Equilibrium Simulation using Fluent	enigma	ANSYS	2	October 27, 2011 08:02
FLUENT (2D simulation)	virginia	FLUENT	3	January 28, 2011 02:24
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug	unoder	OpenFOAM Installation	11	January 30, 2008 20:30

September 18, 2012, 04:01		#2
olivierG Senior Member Olivier Join Date: Jun 2009 Location: France, grenoble Posts: 272 Rep Power: 17	hello, There is a tool in the 1.6-ext called "fluentDataToFoam" which should do the job. So you need to try the 1.6-ext version, or try to copy & compile in your 2.1 version. regards, olivier

September 18, 2012, 04:44		#3
samiam1000 Senior Member Samuele Z Join Date: Oct 2009 Location: Mozzate - Co - Italy Posts: 520 Rep Power: 18	Thanks a lot. I tryed to compile it, but it does not work. I'll work on it. Thanks a lot, Samuele