CFD Online Discussion Forums

CFD Online Discussion Forums (
-   OpenFOAM (
-   -   extract line normal to the surface (

JackW September 25, 2012 12:19

extract line normal to the surface
Hi guys,

Basically, I am sure it is pretty simple, but I am doing a RANS simulation around an aerofoil and I would like to extract selections normal to the aerofoil, in order to plot the velocity profile and calculate boundary layer thickness

Although I have looked through the forum and not found anything that I understand (pretty new to OF)

Any help would be greatly appreciated,


P.S. I'm not sure if anyone has done this before either, but I would like to be able to count the number of points in the boundary layer (I am using an unstructured mesh all the way to the wall)


All times are GMT -4. The time now is 08:42.