|October 25, 2012, 15:41||
combine dynamicMotionSolverFvMesh and solidBodyMotionFvMesh
Join Date: Jan 2012
Posts: 18Rep Power: 5
I'm interested in simulating a helicopter rotor.
I've done this with solidBodyMotion with AMI at the interface and works well
I would like to combine the two mesh solvers, dynamicMotionSolverFvMesh and solidBodyMotionFvMesh. Ideally, I want the rotating domain of the mesh to
use mesh elasticity on the rotor blade (located in the center of the rotating domain).
I tried using rotatingWallVelocity and just use dynamicMotionSolverFvMesh. Which does work, but the rotatingWall BC's doesn't work for blades (non circular surfaces)
It seems possible, but don't really know where to start. I assume many could benefit from the functionality.
Any suggestions as to where to start or any dev. versions which have incorporated this.
|July 9, 2013, 03:43||
Join Date: Mar 2013
Posts: 1Rep Power: 0
I meet the same question as yours, and how did you solve this problem? Is there some suggestions?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Combine non rotating part with rotating parts or not ?||teck0516||Main CFD Forum||0||July 16, 2011 13:38|
|How to combine UDF and Scheme?||ali hemmati||Fluent UDF and Scheme Programming||3||March 19, 2011 15:45|
|how to combine parts of MRFSimpleFoam and TurbFoam to create a new solver?||renyun0511||OpenFOAM Running, Solving & CFD||0||May 3, 2010 22:10|
|how to combine multiple block files in ICEM?||kpv||CFX||3||December 13, 2007 09:12|
|how combine two volume MESHES in GAMBIT||sreenivas||FLUENT||2||October 10, 2007 10:48|