Get layer cells

Tobi · October 26, 2012, 14:45

Hi all,

if you use sHM for adding layer cells you get a Set of "addedCells". If I use sHM on one core thats not a problem to visualize them with the command

Code:

foamToVTK -cellSet addedCells

but if I have a decomposed mesh I am out of ideas how to get the cells.

Well okay I can make VTK for every processor but thats to many work

Is there a possibility to use a command or sth. like that?

Tobi

wyldckat · October 26, 2012, 18:53

Hi Tobi,

You can run foamToVTK in parallel as well for exporting said cellSet. It should create symbolic links in the VTK to each processor folder.

The other possibility is to use ParaView's internal foam reader and open the parallel case directly:

Code:

paraFoam -builtin

I believe there is an option for also displaying sets...

Best regards,
Bruno

October 26, 2012, 14:45	Get layer cells	#1
Tobi Super Moderator Tobias Holzmann Join Date: Oct 2010 Location: Tussenhausen Posts: 2,708 Blog Entries: 6 Rep Power: 51	Hi all, if you use sHM for adding layer cells you get a Set of "addedCells". If I use sHM on one core thats not a problem to visualize them with the command Code: foamToVTK -cellSet addedCells but if I have a decomposed mesh I am out of ideas how to get the cells. Well okay I can make VTK for every processor but thats to many work Is there a possibility to use a command or sth. like that? Tobi

October 26, 2012, 18:53		#2
wyldckat Retired Super Moderator Bruno Santos Join Date: Mar 2009 Location: Lisbon, Portugal Posts: 10,974 Blog Entries: 45 Rep Power: 128	Hi Tobi, You can run foamToVTK in parallel as well for exporting said cellSet. It should create symbolic links in the VTK to each processor folder. The other possibility is to use ParaView's internal foam reader and open the parallel case directly: Code: paraFoam -builtin I believe there is an option for also displaying sets... Best regards, Bruno __________________ OpenFOAM: FAQ \| Getting started Forum: How to get help, to post code/output and forum guide Read this before sending me PM

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 09:38
[Netgen] Import netgen mesh to OpenFOAM	hsieh	OpenFOAM Meshing & Mesh Conversion	32	September 13, 2011 05:50
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11
physical boundary error!!	kris	Siemens	2	August 3, 2005 00:32
errors	Fahad	Main CFD Forum	0	March 23, 2004 13:20