 |
 |
 |
|
|
|
[Sponsors] | ||||
November 9, 2012, 09:06
|
Wrong Oriented Faces checkMesh
|
#1 |
|
New Member
Kentin cal
Join Date: May 2012
Posts: 11
Rep Power: 13  |
hello everybody,
I am dealing with a problem concerning OF mesh checking : pier_of.PNG The picture above shows a draft tube pier. On the nose is concentrated all my problem. The blue part corresponds to the nose and more specifically to wrong Oriented Faces. I tried many stuff but i do not know how to fix this problem. I use an hexa meshing for information thanks for your help! Kentin |
|
|
|
|
 |
| Tags |
| openfoam checkmesh faces |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 07:34 |
| AMI speed performance | danny123 | OpenFOAM | 21 | October 24, 2020 04:13 |
| GGI and Topological changes - checkMesh fails | strakakl | OpenFOAM Programming & Development | 4 | November 10, 2019 05:48 |
| Wrong oriented faces due to opposite face bends? | Arnoldinho | OpenFOAM | 5 | August 16, 2012 05:00 |
| Problem in IMPORT of ICEM input file in FLUENT | csvirume | FLUENT | 2 | September 9, 2009 01:08 |
Linear Mode
