interFoam pb

lyna · December 5, 2012, 06:09

hello,

I work on two-phase flow in a pipe. I used the application interFoam for it.
My problem is when I reduced the diameter of the results that I will not have a physical meaning. at any given time The results are correct (I will have well-formed bubble), but from some time t deviennemt dispersed bubbles.
the enclosed my results, can you tell me how I should fix this problem please?

wouter · December 6, 2012, 09:09

Hello,
Could you sent a little more information? I just started working on a similar problem. I do not have results (yet), but maybe we can help each other.

Best
Wouter

lyna · December 10, 2012, 11:42

hi

please help me, I want to know what caused this problem?
I refined my mesh but it gives the same results?

Lyna

wouter · December 10, 2012, 12:59

Hello Lyna,
Without more information it is very impossible to help you. Please read the first item in the CFD online forum. (http://www.cfd-online.com/Forums/ope...-get-help.html).

With my simulation I tried to change the outlet boundary conditions and that helped.

Best regards
Wouter

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Free Surface Ship Flow	timfranke	OpenFOAM Running, Solving & CFD	322	March 3, 2021 09:04
InterFoam stops after deltaT goes to 1e14	francesco_b	OpenFOAM Running, Solving & CFD	9	July 25, 2020 06:36
Segmentation fault in interFoam run through openMPI	voingiappone	OpenFOAM	16	November 2, 2011 06:49
Slow interFoam compared with other CFD tools?	Ralph M	OpenFOAM Programming & Development	1	November 17, 2010 06:46
Open Channel Flow using InterFoam type solver	sxhdhi	OpenFOAM Running, Solving & CFD	3	May 5, 2009 21:58

December 6, 2012, 09:09		#2
wouter Senior Member Wouter van der Meer Join Date: May 2009 Location: Elahuizen, Netherlands Posts: 203 Rep Power: 17	Hello, Could you sent a little more information? I just started working on a similar problem. I do not have results (yet), but maybe we can help each other. Best Wouter

December 10, 2012, 11:42		#3
lyna Member lynda Join Date: Oct 2009 Posts: 52 Rep Power: 16	hi please help me, I want to know what caused this problem? I refined my mesh but it gives the same results? Lyna

December 10, 2012, 12:59		#4
wouter Senior Member Wouter van der Meer Join Date: May 2009 Location: Elahuizen, Netherlands Posts: 203 Rep Power: 17	Hello Lyna, Without more information it is very impossible to help you. Please read the first item in the CFD online forum. (http://www.cfd-online.com/Forums/ope...-get-help.html). With my simulation I tried to change the outlet boundary conditions and that helped. Best regards Wouter