Keep sets when mergeMeshes

Horus · December 30, 2012, 11:48

Hello,

I've two meshes which were created using fluentMeshToFoam -writeSets -writeZones. These meshes are merged using mergeMeshed -overwrite.

The original meshes contain zone and set information, however in the merged mesh this is lost.

Is there any way to keep / recreate zones/sets? My goal is to use tools like mergeOrSplitBaffles and at the end dynamicMeshMotion with AMI.

Thanks!

Horus · January 2, 2013, 06:51

I've found this bug report regarding the issue: http://www.openfoam.org/mantisbt/view.php?id=432

However, it should be fixed in 2.1.x. Anybody could confirm that? I try with 2.1.1 and it does not seem to work.

December 30, 2012, 11:48	Keep sets when mergeMeshes	#1
Horus Member Florian Join Date: Nov 2009 Posts: 59 Rep Power: 16	Hello, I've two meshes which were created using fluentMeshToFoam -writeSets -writeZones. These meshes are merged using mergeMeshed -overwrite. The original meshes contain zone and set information, however in the merged mesh this is lost. Is there any way to keep / recreate zones/sets? My goal is to use tools like mergeOrSplitBaffles and at the end dynamicMeshMotion with AMI. Thanks!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
MergeMeshes with version OF14	jens_klostermann	OpenFOAM Bugs	2	November 7, 2014 16:27
[mesh manipulation] MergeMeshes	hsieh	OpenFOAM Meshing & Mesh Conversion	3	September 10, 2014 09:15
[ICEM] Exporting node sets from ICEM CFD	automation	ANSYS Meshing & Geometry	1	September 7, 2012 14:47
[mesh manipulation] MergeMeshes and stitchMesh problem	flo	OpenFOAM Meshing & Mesh Conversion	6	May 10, 2010 10:40
[Technical] Definition of mesh sets	chbenz	OpenFOAM Meshing & Mesh Conversion	0	April 7, 2009 10:00

January 2, 2013, 06:51		#2
Horus Member Florian Join Date: Nov 2009 Posts: 59 Rep Power: 16	I've found this bug report regarding the issue: http://www.openfoam.org/mantisbt/view.php?id=432 However, it should be fixed in 2.1.x. Anybody could confirm that? I try with 2.1.1 and it does not seem to work.