How to set a right initial conditions for a wall-jet flow case using rhoPimpleFoam -- CFD Online Discussion Forums

January 5, 2013, 04:02	How to set a right initial conditions for a wall-jet flow case using rhoPimpleFoam	#1
Sunxing Member sqing Join Date: Sep 2012 Location: Dalian Posts: 77 Rep Power: 13	Hi Foamers, I am simulating a wall-jet flow case using the LaunderSharmaKE model(RANS) with the rhoPimpleFoam solver. In the case, I know exactly the inlet velocity, so I set the inlet velocity as fixed value. However, I don't know how to set the outlet velocity and the inlet/outlet condition for the pressure. Can anybody give me a hint? Regards Sunxing

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
AMI speed performance	danny123	OpenFOAM	21	October 24, 2020 04:13
MRFSimpleFoam wind turbine case diverges	ysh1227	OpenFOAM Running, Solving & CFD	2	May 7, 2015 10:13
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 03:32
Interfoam blows on parallel run	danvica	OpenFOAM Running, Solving & CFD	16	December 22, 2012 02:09
Low Mach number Compressible jet flow using LES	ankgupta8um	OpenFOAM Running, Solving & CFD	7	January 15, 2011 13:38

All times are GMT -4. The time now is 08:55.