CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > OpenFOAM

How to set a right initial conditions for a wall-jet flow case using rhoPimpleFoam

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   January 5, 2013, 05:02
Default How to set a right initial conditions for a wall-jet flow case using rhoPimpleFoam
  #1
Member
 
sqing
Join Date: Sep 2012
Location: Dalian
Posts: 77
Rep Power: 13
Sunxing is on a distinguished road
Hi Foamers,

I am simulating a wall-jet flow case using the LaunderSharmaKE model(RANS) with the rhoPimpleFoam solver. In the case, I know exactly the inlet velocity, so I set the inlet velocity as fixed value. However, I don't know how to set the outlet velocity and the inlet/outlet condition for the pressure. Can anybody give me a hint?

Regards

Sunxing
Sunxing is offline   Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
AMI speed performance danny123 OpenFOAM 21 October 24, 2020 05:13
MRFSimpleFoam wind turbine case diverges ysh1227 OpenFOAM Running, Solving & CFD 2 May 7, 2015 11:13
Water subcooled boiling Attesz CFX 7 January 5, 2013 04:32
Interfoam blows on parallel run danvica OpenFOAM Running, Solving & CFD 16 December 22, 2012 03:09
Low Mach number Compressible jet flow using LES ankgupta8um OpenFOAM Running, Solving & CFD 7 January 15, 2011 14:38


All times are GMT -4. The time now is 21:51.