Cyclic rotor stator boundary condition problem

fairuz · January 10, 2014, 02:50

Hi....

I'm new to openfoam. I just try to model the simple rotor and stator of 2d case in SRFSimpleFoam using the cyclic bc. However, the pressure and the Urel in the cyclic bc area seem not to correctly patched with each other as attached below for you 2 try. Hope somebody can help me......

fairuz · January 14, 2014, 01:48

Ok...now i know what is the problem. I have to use create-periodic when using pointwise......

Jiricbeng · April 25, 2014, 04:49

Would you mind uploading your corrected case with create periodic? It would help me a lot.

fairuz · April 26, 2014, 00:16

Do u have email...I'll email it 2 u....Tq

January 14, 2014, 01:48	Solved	#2
fairuz New Member fairuz Join Date: Jan 2014 Location: University of Queensland, Australia Posts: 4 Rep Power: 12	Ok...now i know what is the problem. I have to use create-periodic when using pointwise......

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] icem fluent mesh with cyclic boundary condition	jiejie	OpenFOAM Meshing & Mesh Conversion	2	February 24, 2020 03:34
Using sprayFOAM on cyclic problem with wedge boundaries	Mentalo	OpenFOAM Running, Solving & CFD	5	September 7, 2018 02:12
Cyclic boundary condition for dnsFoam	antoinep76	OpenFOAM Programming & Development	7	March 18, 2013 04:54
[Commercial meshers] Handling cyclic BC from gambit to openfoam for a cascade airfoil problem - OF 1.6	maverick	OpenFOAM Meshing & Mesh Conversion	2	June 18, 2011 04:36
Boundary condition on 3D Supersonic nozzle problem with atmosphere	dokeun	FLUENT	0	April 1, 2010 21:59

April 25, 2014, 04:49		#3
Jiricbeng Senior Member Jiri Join Date: Mar 2014 Posts: 218 Rep Power: 13	Would you mind uploading your corrected case with create periodic? It would help me a lot.

April 26, 2014, 00:16		#4
fairuz New Member fairuz Join Date: Jan 2014 Location: University of Queensland, Australia Posts: 4 Rep Power: 12	Do u have email...I'll email it 2 u....Tq