CFD Online Discussion Forums

CFD Online Discussion Forums (
-   OpenFOAM (
-   -   Help with tutorial (

jgil9 April 2, 2013 07:11

Help with tutorial
I am looking for some guidance on openFOAM MS (openfoam desinger v 1.0) . I am new to OpenFOAM and I have been following the tutorial case cavity, but have had problems when running paraview. I was able generate the mesh and paraview loaded fine but I am not able to load any files of this tutorial into paraview. I am running openFOAM under win7, 64bit bootcamped Mac.
Thanks, any help is greatly apreciated.

All times are GMT -4. The time now is 06:23.