Turbomolecular pump simulation
How can I simulate a turbomolecular pump using dsmcFoam?
|
its a too general question :)
every simulation has three parts: 1- pre-processing ( generate mesh, assign boundary condition, define properties and so on ) 2- processing ( run your solver which is here dsmcFoam) 3- post-processing ( see result at paraview and so on and compare results) now what exactly your problem? in which part? if you are beginner, i suggest you to read user-guide and run some test cases before start your case ;) |
Dear nimasam
Hi nimasam
Thanks for your reply I am a new user of openfoam and I will try to start simulating by generating mesh and so on. I will ask my questions. thanks in advance |
All times are GMT -4. The time now is 04:31. |