|July 30, 2013, 12:54||
problem about pressure boundary condition at sharp corner
Join Date: Jan 2012
Location: Madison, Wisconsin, USA
Posts: 56Rep Power: 5
I have a question about the pressure boundary condition. Usually people use zeroGradient condition for pressure at wall. This condition works fine for most situations. But I have a sharp corner in my simulation, the this condition will cause a singularity and this corner. The pressure at this point keeps decreasing and never recover.
Does anyone know if there is other condition we can set for pressure at wall??
thank you all in advance.~
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wind turbine simulation||Saturn||CFX||34||October 16, 2014 05:27|
|Radiation interface||hinca||CFX||15||January 26, 2014 18:11|
|Pressure Boundary Condition Problem||rbjet||CFX||3||July 15, 2013 21:45|
|Question about heat transfer coefficient setting for CFX||Anna Tian||CFX||1||June 16, 2013 06:28|
|Pressure Velocity boundary condition problem||deepsterblue||OpenFOAM Running, Solving & CFD||3||September 24, 2008 07:19|