How to fix problem with "decomposePar: command not found"?

mchehab2 · March 30, 2016, 14:13

Hello,

I was trying to apply the solver for K-Epsilon model, and i had this error. can anyone help me with it? Thank you

akidess · March 31, 2016, 02:39

I recommend reading the user guide. None of your OpenFOAM executables are present. Either you didn't compile properly or you didn't source.

taxalian · March 31, 2016, 06:26

Hi,

you need to decompose your grid before using the parallel mode. Because it requires the decomposed processor directories to start the simulation and i cannot see the processor rank directories in the attached file in your working directory. Make sure that you have the "decomposePar" dictionary in your "system" folder. If not then do that, otherwise you can start the computation in serial mode taking into account the size of your mesh.

good luck

March 31, 2016, 02:39		#2
akidess Senior Member Anton Kidess Join Date: May 2009 Location: Germany Posts: 1,377 Rep Power: 29	I recommend reading the user guide. None of your OpenFOAM executables are present. Either you didn't compile properly or you didn't source. __________________ On twitter @akidTwit Spend as much time formulating your questions as you expect people to spend on their answer.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 06:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13
entropy fix for Riemann problem	vivek kumar	Main CFD Forum	3	August 31, 2005 07:47
extremely simple problem... can you solve it properly?	Mikhail	Main CFD Forum	40	September 9, 1999 09:11
Is this problem well posed?	Thomas P. Abraham	Main CFD Forum	5	September 8, 1999 14:52

March 31, 2016, 06:26		#3
taxalian Senior Member Join Date: Nov 2010 Posts: 139 Rep Power: 15	Hi, you need to decompose your grid before using the parallel mode. Because it requires the decomposed processor directories to start the simulation and i cannot see the processor rank directories in the attached file in your working directory. Make sure that you have the "decomposePar" dictionary in your "system" folder. If not then do that, otherwise you can start the computation in serial mode taking into account the size of your mesh. good luck