|December 29, 2013, 09:41||
DieselFoam with chem.inp.full ERROR
Join Date: Dec 2012
Posts: 21Rep Power: 4
I have been banging on walls to make dieselFoam and sprayFoam to model diesel spray combustion for a while but to no avail. I made 2D wedge case mesh with chem.inp chemkin model on foam-extend-3.0. The chemkin model chemkin.inp.full was tested functional with chemfoam with OpenFOAM-2.2.x.
Attached below is my case setup. The temperature kept dropping below 200 and was saved by HJ (Good reason to do so and thank you for saving my time). There must something wrong with my case setup that cause rapid evaporation and drop the temperature below 200K. Is it the time-step too large? Is it the mean particle too small? Is parcel speed to large? Or my mesh is just broken. Or the JANAF model is broken or inappropriate.
Any pointers on what's my next move will be greatly appreciated.
Last edited by RJ87; December 29, 2013 at 09:44. Reason: Attachment
|Thread||Thread Starter||Forum||Replies||Last Post|
|GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh||gschaider||OpenFOAM||300||October 29, 2014 19:00|
|c++ libraries and solver compiling||vaina74||OpenFOAM Installation||13||February 3, 2012 18:43|
|Saving ParaFoam views and case||sail||OpenFOAM Paraview & paraFoam||9||November 25, 2011 16:46|
|Problem with compile the setParabolicInlet||ivanyao||OpenFOAM Running, Solving & CFD||6||September 5, 2008 20:50|
|user defined function||cfduser||CFX||0||April 29, 2006 10:58|