|
[Sponsors] |
April 22, 2015, 12:23 |
Non uniform FixedJump
|
#1 |
New Member
Francesco
Join Date: Jul 2014
Posts: 26
Rep Power: 11 |
Hi,
again i need the community help. I try to create a annular patch to simulate a fan, i use the topoSet and createBaffles utilities for generate the patch and the fan patch is set as fixedJump. But when i simulate the pressure jump is not uniform in the patch and the jet is not axial. Any suggestion? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
dsmcFoam setup | hherbol | OpenFOAM Pre-Processing | 1 | November 19, 2021 01:52 |
T Junction Stability | ignacio | OpenFOAM Running, Solving & CFD | 5 | May 2, 2013 10:44 |
[swak4Foam] Air Conditioned room groovyBC | Sebaj | OpenFOAM Community Contributions | 7 | October 31, 2012 14:16 |
Need help with boundary conditions: open to atmosphere | Wolle | OpenFOAM | 2 | April 11, 2011 07:32 |
rhoSimpleFoam | claco | OpenFOAM | 7 | April 20, 2010 04:32 |