CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM (http://www.cfd-online.com/Forums/openfoam/)
-   -   Bioengineering application of Foam (http://www.cfd-online.com/Forums/openfoam/60972-bioengineering-application-foam.html)

msekandi1 June 21, 2006 11:15

Hi, I was wondering if anyo
 
Hi,

I was wondering if anyone has seen or done any arterial flow (or general blood flow) modelling with Foam. I am going to try and use Foam for this application, so I just would like to know about any cases of this usage.

Any response would be much appreciated.

Regards,

Michael

hjasak June 21, 2006 11:48

Lots. Have a look at the pres
 
Lots. Have a look at the presentation by
prof. Ivankovic's group from University College Dublin and the OpenFOAM Workshop in Zagreb in January 2006. I have been collaborating with them for a number of years now and this is just a part of their work with OpenFOAM. The following link contains the presentation slides.

If you'd like to know more, please give me a shout.

Hrv

msekandi1 June 22, 2006 04:30

Thanks a lot for that informat
 
Thanks a lot for that information. I will look into his work.

Regards,

Michael

grtabor June 22, 2006 07:46

I'm doing quite a lot of biofl
 
I'm doing quite a lot of biofluids work at the moment linking in with a tool for image-to-mesh conversion for generating patient-specific geometries (ScanIP/ScanFE from Simpleware Ltd). Unfortunately a. this is commercial rather than open source software and b. the only CFD output at the moment is to Fluent. However one of my long term aims is to rectify b. by getting an OpenFOAM mesh output module written.

Drop me a line if any of this interests you : g.r.tabor@ex.ac.uk

Gavin


All times are GMT -4. The time now is 18:30.