|August 26, 2009, 23:15||
interFoam pressure conservation
Join Date: Jul 2009
Posts: 1Rep Power: 0
I am trying to run some free surface cases using interFoam where I have 1 atm of pressure in the air and 2 atm of pressure in the water. The geometry is small enough such that the pressure difference should be accounted for by the surface tension of the water.
At present I am setting the two pressures in the initial conditions, however after the first timestep, the patched pressure has disappeard and all i have is the hydrostatic pressure from the water.
Am I missing something or is interFoam not capable of dealing with a discontinuous pressure.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Pressure Condition||sidd||CD-adapco||0||April 2, 2007 09:31|
|measured pressure in the discharge pipe jumps||Jan||Main CFD Forum||1||October 30, 2006 08:54|
|Setting pressure and velocity in inlet||Asghari||FLUENT||5||September 22, 2006 13:23|
|Neumann pressure BC and velocity field||Antech||Main CFD Forum||0||April 25, 2006 02:15|
|Pressure Boundary Problems||Chris||CD-adapco||2||June 21, 2005 08:20|