|November 1, 2009, 14:07||
Tutorial problem: "rhopSonicFoam - shockTube" with high pressure
Join Date: Oct 2009
Posts: 51Rep Power: 9
For getting experience in high pressure simulation I try out the "shockTube" turotial of rhopSonicFoam.
When unchanged, the tutorial works fine.
But when I changethe pressure in "SetFieldsDict" to a higher value (100.000.000 instead of 10.000 Pa), simulation fails.
I cannot figure out what settings to change for the simulation of that high pressures. Is it because of the boundary conditions or is this more of a solver setup problem?
Is someone experienced in setting up a high pressure case?
|Thread||Thread Starter||Forum||Replies||Last Post|
|HELP! rail tunnel pressure problem||miguel.berrozpe||Main CFD Forum||1||February 14, 2012 09:35|
|Pressure profile UDF for unsteady-state problem?||Mohsen Keshavarzian||FLUENT||2||August 20, 2008 04:22|
|problem with static pressure||Nina||FLUENT||3||February 28, 2008 14:08|
|High pressure flow||David||CFX||4||November 11, 2002 09:46|
|Hydrostatic pressure in 2-phase flow modeling (long)||DS & HB||Main CFD Forum||0||January 8, 2000 16:00|