|November 14, 2009, 23:12||
postProcessing with R, I have run,but no file created ?
Join Date: Oct 2009
Posts: 186Rep Power: 7
In version1.6 , I saw a R utility, whick can be used to creat Reynolds stress. But after I have run this ,no file was created . Who khows what is the problem.
|November 20, 2009, 14:01||
Join Date: Jun 2009
Posts: 38Rep Power: 7
Hi - what kind of turbulence model are you using?
The post-processing tool R creates the Reynolds-Stress-Tensor on the base of k - the turbulent kin. engergy. So make sure to run a model which calculates k.
Hope this helps you! Good luck.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Changing the grid on the same set-up||Katya||FLUENT||12||October 8, 2009 16:31|
|ParaView Compilation||jakaranda||OpenFOAM Installation||3||October 27, 2008 12:46|
|FoamToVTK and MayaVi||alexandrepereira||OpenFOAM Post-Processing||57||August 11, 2008 04:15|
|HELPInstallation on RedHat90||booosix||OpenFOAM Installation||8||July 17, 2007 06:40|
|Importing I-DEAS unv file||hbetb||FLUENT||1||August 10, 2001 13:22|