postProcessing with R, I have run,but no file created ?

panda60 · November 14, 2009, 22:12

Dear all.
In version1.6 , I saw a R utility, whick can be used to creat Reynolds stress. But after I have run this ,no file was created . Who khows what is the problem.
Thank you!

svens · November 20, 2009, 13:01

Hi - what kind of turbulence model are you using?

The post-processing tool R creates the Reynolds-Stress-Tensor on the base of k - the turbulent kin. engergy. So make sure to run a model which calculates k.

Hope this helps you! Good luck.
Sven

November 14, 2009, 22:12	postProcessing with R, I have run,but no file created ?	#1
panda60 Senior Member Jiang Join Date: Oct 2009 Location: Japan Posts: 186 Rep Power: 16	Dear all. In version1.6 , I saw a R utility, whick can be used to creat Reynolds stress. But after I have run this ,no file was created . Who khows what is the problem. Thank you!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Changing the grid on the same set-up	Katya	FLUENT	7	October 8, 2009 16:31
ParaView Compilation	jakaranda	OpenFOAM Installation	3	October 27, 2008 11:46
FoamToVTK and MayaVi	alexandrepereira	OpenFOAM Post-Processing	57	August 11, 2008 04:15
HELPInstallation on RedHat90	booosix	OpenFOAM Installation	8	July 17, 2007 06:40
Importing I-DEAS unv file	hbetb	FLUENT	1	August 10, 2001 13:22

November 20, 2009, 13:01		#2
svens Member Sven Schweikert Join Date: Jun 2009 Posts: 38 Rep Power: 16	Hi - what kind of turbulence model are you using? The post-processing tool R creates the Reynolds-Stress-Tensor on the base of k - the turbulent kin. engergy. So make sure to run a model which calculates k. Hope this helps you! Good luck. Sven