Repair mesh after checkMesh

foam_noob · January 12, 2010, 02:52

Hello to all,

I meshed a STL file with snappy and executed checkMesh afterwards to examine the quality of the created mesh. Most of the time, I have a couple of skewFaces.

I tried to use commands like setSet, but I didn't get far since I do not know which commands I have to type in after.

Can someone please explain the steps and write the exact commands needed to repair/delete the flawed elements?

Thanks in advanced,

Patrick

foam_noob · January 19, 2010, 09:54

This is the one million dollar question ladies and gents.

.... Anybody?

January 12, 2010, 02:52	Repair mesh after checkMesh	#1
foam_noob New Member Patrick Wang Join Date: Dec 2009 Location: Stuttgart, Germany Posts: 26 Rep Power: 16	Hello to all, I meshed a STL file with snappy and executed checkMesh afterwards to examine the quality of the created mesh. Most of the time, I have a couple of skewFaces. I tried to use commands like setSet, but I didn't get far since I do not know which commands I have to type in after. Can someone please explain the steps and write the exact commands needed to repair/delete the flawed elements? Thanks in advanced, Patrick

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dynamic Mesh Problem.	Tom Clark	FLUENT	10	June 21, 2021 04:27
[Other] vtk mesh or Abaqus mesh to OpenFOAM	bigphil	OpenFOAM Meshing & Mesh Conversion	27	November 23, 2015 17:31
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation	tommymoose	ANSYS Meshing & Geometry	48	April 15, 2013 04:24
[snappyHexMesh] external flow with snappyHexMesh	chelvistero	OpenFOAM Meshing & Mesh Conversion	11	January 15, 2010 19:43
basic of mesh refinement	arya	CFX	4	June 19, 2007 12:21

January 19, 2010, 09:54		#2
foam_noob New Member Patrick Wang Join Date: Dec 2009 Location: Stuttgart, Germany Posts: 26 Rep Power: 16	This is the one million dollar question ladies and gents. .... Anybody?