|
[Sponsors] |
Is there a way, to exclude individual regions (just to use them as boundary for BCs) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 16, 2010, 04:52 |
Is there a way, to remove regionsmesh (just to use their boundaries for BCs)
|
#1 |
Member
Join Date: Jun 2009
Location: Germany
Posts: 38
Rep Power: 16 |
Hi guys,
I'm using snappyHexMesh and I've no clue integrating to seperate contact areas for the boundary conditions. The only way I found is to create addition Regions and use the boundaries between the additional regions and the other region as new contact surface (for the bc). The problem is that the additional regions are also calculated and cost simulation time. Has someone experience with such issues or know another way. Thanks in advance. Last edited by suitup; February 16, 2010 at 13:11. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Boundary Conditions | Thomas P. Abraham | Main CFD Forum | 20 | July 7, 2013 05:05 |
Immersed Boundary Ghost Cell Method | thehexman | Main CFD Forum | 1 | February 5, 2010 06:10 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
CFX doesn't continue calculation... | mactech001 | CFX | 6 | November 15, 2009 21:25 |
Boundary Conditions | Jan Ramboer | Main CFD Forum | 11 | August 16, 1999 08:59 |