 |
 |
 |
|
|
|
[Sponsors] | ||||
April 26, 2010, 09:36
|
stitchMesh
|
#1 |
|
Member
Marine
Join Date: Mar 2010
Posts: 38
Rep Power: 16  |
Hello everybody,
I merged two meshes using mergeMeshes and I'd like to join the two faces of the intersection of the meshes. I use stitchMesh and he seems to work because it creates a new polyMeshfile but when I look at the mesh in paraview I can still see the 2 faces. Should I delete them or should I use a special option ? If someone has any documentation about stitchMesh I'd enjoy it! thank you, Marine |
|
|
|
|
|
April 27, 2010, 10:59
|
there is still a patch
|
#2 |
|
Member
Marine
Join Date: Mar 2010
Posts: 38
Rep Power: 16 |
I finally obtained one only face, but it 's still a patch of my domain and I'd like to get rid of it because it's in the middle of my domain and I don't want to specify boundary condition in this place!
does someone know how to transform this interface in a no-patch?  Marine |
|
|
|
|
|
 |
| Tags |
| stitchmesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [mesh manipulation] stitchMesh perfect vs partial | Eloise | OpenFOAM Meshing & Mesh Conversion | 2 | October 25, 2017 10:47 |
| [mesh manipulation] stitchMesh: multiple meshes | GerhardHolzinger | OpenFOAM Meshing & Mesh Conversion | 3 | August 25, 2017 12:43 |
| [mesh manipulation] StitchMesh sigFpe / bad point | liquidspoon | OpenFOAM Meshing & Mesh Conversion | 2 | November 29, 2015 14:19 |
| [snappyHexMesh] SnappyHexMesh and StitchMesh | New_OpenFOAM_user | OpenFOAM Meshing & Mesh Conversion | 1 | September 7, 2014 16:53 |
| [mesh manipulation] stitchMesh | dhruv | OpenFOAM Meshing & Mesh Conversion | 13 | February 23, 2012 17:14 |
Linear Mode
