Post-processing in Ensight

invincible328 · June 21, 2010, 19:31

Dear All,

I simulated the flow past a cylinder in OpenFOAM and took it to Ensight for post-processing. Can anyone help me with calculating Strouhal number in Ensight? I am very confused with the interface. Please help me out. Thanks in advance.

P.S. Sorry for posting this in OpenFOAM forum. I did not know where else to post it.

madad2005 · June 22, 2010, 04:50

There is a calculator within EnSight that will allow you to compute what you want. I can't remember exactly where it is, but there should be a button along the top bar to use it. I think it is the second or third from the left (the first being the legend settings). You could do the same thing easily in ParaView and the layout is also much clearer.

June 21, 2010, 19:31	Post-processing in Ensight	#1
invincible328 New Member Rajiv Join Date: Mar 2010 Posts: 5 Rep Power: 16	Dear All, I simulated the flow past a cylinder in OpenFOAM and took it to Ensight for post-processing. Can anyone help me with calculating Strouhal number in Ensight? I am very confused with the interface. Please help me out. Thanks in advance. P.S. Sorry for posting this in OpenFOAM forum. I did not know where else to post it.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
post processing of Kiva results using ensight	vedhusiva	Main CFD Forum	1	June 24, 2010 12:36
post processing for KIVA	dirga	Main CFD Forum	5	April 23, 2009 10:58
Tecplot for CFX post processing	pantangi goud	CFX	2	August 24, 2005 16:42
Post Processing in FEM	Abhijit Tilak	Main CFD Forum	0	April 26, 2004 11:59
post processing in CFD	MANISH BHARGAVA	Main CFD Forum	0	October 17, 1998 20:51

June 22, 2010, 04:50		#2
madad2005 Senior Member Anonymous Join Date: Mar 2009 Posts: 110 Rep Power: 17	There is a calculator within EnSight that will allow you to compute what you want. I can't remember exactly where it is, but there should be a button along the top bar to use it. I think it is the second or third from the left (the first being the legend settings). You could do the same thing easily in ParaView and the layout is also much clearer.