CFD Online Discussion Forums

CFD Online Discussion Forums (
-   OpenFOAM (
-   -   DieselFoam massflow (

Rickard.Solsjo August 10, 2010 05:40

DieselFoam massflow
Hi !
I think I'm getting errors due to perhaps using a top-hat for injecting my fuel into my cylinder. I'm injecting for about 200microseconds with just 0.7mg of fuel. I read in another post that using a top-hat or similar, a too high temperature can be obtained causing an error due to the interpolation scheme.
Does anyone have experience in this ?


All times are GMT -4. The time now is 16:50.