|
[Sponsors] |
August 10, 2010, 06:40 |
DieselFoam massflow
|
#1 |
Senior Member
Rickard
Join Date: May 2010
Location: Lund, Skåne, Sweden
Posts: 143
Rep Power: 15 |
Hi !
I think I'm getting errors due to perhaps using a top-hat for injecting my fuel into my cylinder. I'm injecting for about 200microseconds with just 0.7mg of fuel. I read in another post that using a top-hat or similar, a too high temperature can be obtained causing an error due to the interpolation scheme. Does anyone have experience in this ? Thx R |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
injector model in dieselFoam | leejc | OpenFOAM | 8 | April 3, 2018 13:30 |
axi-symmetric mesh of dieselFoam | az1362f | OpenFOAM Running, Solving & CFD | 2 | June 27, 2009 12:32 |
calculate MASSFLOW for a component | MAldaz | CFX | 1 | November 7, 2007 12:41 |
massflow outlet in flunet. | shrinath | FLUENT | 0 | September 3, 2007 10:40 |
re: Massflow reset in CFX 10 | Wooster | CFX | 5 | March 16, 2007 21:08 |