 |
 |
 |
|
|
|
[Sponsors] | ||||
October 19, 2010, 05:29
|
Molecular Dynamic thermostats
|
#1 |
|
Member
Mehdi
Join Date: Oct 2009
Posts: 61
Rep Power: 16  |
Hi all
Here in openFoam 1.6 for simulation of flow using molecular Dynamic method we have as default the simplified "BERENDSEN" method, in my run i set the "Target temperature" to 300K but the simulation converges to 1020K !!! resulting in much lower density than anticipated. How can i make sure the thermostat is working or not? Is there any reasons for this high deviation of target and the measuredTemperature??? Kind Regards |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dynamic Mesh Problem. | Tom Clark | FLUENT | 10 | June 21, 2021 04:27 |
| Dynamic Mesh on Pintle type injector. | herntan | FLUENT | 16 | September 4, 2020 08:27 |
| Regarding Negative volume detected in Dynamic mesh | Vinay Morabad | FLUENT | 10 | December 16, 2015 00:31 |
| Molecular Dynamic | m.maneshi | OpenFOAM Running, Solving & CFD | 0 | September 23, 2010 09:44 |
| Dynamic Mesh moving interface help | akash.iitb | FLUENT | 0 | August 23, 2010 23:53 |
Linear Mode
