[efirvida]

Hello everybody. I´m running a Of-extend case on a mpi cluster, after a few weeks the cluster hardware was updated. So now I want to run the case with more decomposition degree. To do this, I reconstructed the current simulation results, and did a new configuration of the decomposePartDic, but now for the new decomposition the decomposePar tool throws this error:

--> FOAM FATAL ERROR:
 Unknown global face zone insideZone
 Valid face zones are
 0
 (
 )
     From function domainDecomposition::decomposeMesh()
     in file decomposeMesh.C at line 494.
 FOAM exiting

so My question is, if is posible to resume the simulation with a new decomposition dconfiguration?