problem in converting mesh from fluent

kiran · October 30, 2010, 23:22

hi Foamers

i am simulating a 2-D case using sonicFoam solver in OF.1.6
but when i convert the mesh file with .msh extension to OF using 'fluentMeshtoFoam' command, it is extruding 8.9 mm in Z direction but i require only 1 mm.

how can i do this.

regards
Ambilpur Kiran

Ohbuchi · October 31, 2010, 21:35

Hi,

At the line 983 of fluentMeshToFoam.L, 2-dimensional mesh extruded into 3-d.
zOffset is restricted in 0.01*bounding Box size of 2-d mesh.
So you should modify this in the file and make your custom mesh converter.

October 30, 2010, 23:22	problem in converting mesh from fluent	#1
kiran Member kiran Ambilpur Join Date: Jun 2010 Location: India Posts: 50 Rep Power: 15	hi Foamers i am simulating a 2-D case using sonicFoam solver in OF.1.6 but when i convert the mesh file with .msh extension to OF using 'fluentMeshtoFoam' command, it is extruding 8.9 mm in Z direction but i require only 1 mm. how can i do this. regards Ambilpur Kiran

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 06:41
Problem with 2D ICEM mesh check in fluent	Nicola	FLUENT	3	March 25, 2013 05:56
[Gmsh] gmshToFoam problem: not the same mesh in Gmsh vs. paraview	zhernadi	OpenFOAM Meshing & Mesh Conversion	8	July 7, 2011 02:28
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55
A problem about Importing mesh from fluent	aderliner	OpenFOAM Running, Solving & CFD	0	December 18, 2006 23:05

October 31, 2010, 21:35		#2
Ohbuchi Member Masashi Ohbuchi Join Date: Oct 2009 Posts: 74 Rep Power: 16	Hi, At the line 983 of fluentMeshToFoam.L, 2-dimensional mesh extruded into 3-d. zOffset is restricted in 0.01*bounding Box size of 2-d mesh. So you should modify this in the file and make your custom mesh converter.