nonAlignedEdges in snappyHexMesh
Hello,
after meshing with SHM and check with checkMesh tool, there is one failure concerning nonALignedEdges. The message after checkMesh is: Number of edges not aligned with or perpendicular to non-empty directions: 241888 <<Writing 216975 points on non-aligned edges to set nonAlignedEdges. Did somebody know how to fix the problem? Regards Daniel |
Just stumbled over your question, which is still unanswered. I guess after one year you found a solution. However, as I had the same question there might be others as well, so ...
As I understood from https://sites.google.com/site/snappywiki/snappyhexmesh/cylinder-case, one can ignore this problem. I used such a mesh and OpenFoam did not complain. |
All times are GMT -4. The time now is 19:16. |