|January 11, 2011, 04:24||
nonAlignedEdges in snappyHexMesh
Join Date: Nov 2009
Posts: 8Rep Power: 8
after meshing with SHM and check with checkMesh tool, there is one failure concerning nonALignedEdges.
The message after checkMesh is:
Number of edges not aligned with or perpendicular to non-empty directions: 241888
<<Writing 216975 points on non-aligned edges to set nonAlignedEdges.
Did somebody know how to fix the problem?
|January 3, 2013, 08:02||
Join Date: Jan 2011
Posts: 20Rep Power: 6
Just stumbled over your question, which is still unanswered. I guess after one year you found a solution. However, as I had the same question there might be others as well, so ...
As I understood from https://sites.google.com/site/snappywiki/snappyhexmesh/cylinder-case,
one can ignore this problem. I used such a mesh and OpenFoam did not complain.
|aligned, edges, snappyhex, snappyhexmesh|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Createpatch and SnappyHexMesh||hm86||OpenFOAM Native Meshers: snappyHexMesh and Others||1||February 3, 2011 10:50|
|stitchMesh and snappyHexMesh||gdbaldw||OpenFOAM||0||December 23, 2009 03:09|
|SnappyHexMesh||samiam1000||OpenFOAM||0||October 5, 2009 10:32|
|Problem with snappyHexMesh||samiam1000||OpenFOAM||0||October 3, 2009 05:08|
|SnappyHexMesh not generate mesh first time||mavimo||OpenFOAM Mesh Utilities||4||August 26, 2008 07:08|