How to visualise the mach number and pressure coefficient in ParaView

xck1986 · January 19, 2011, 04:28

Hello Foamuser,

I am now using rhoSimpleFoam to simulate the ONERA M6 WING in OpenFOAM.
And I have a question about how to get the mach number and pressure coefficient in ParaView.
Do I also need to set the initial and boundary condition for the Machnumber in the 0 folder?

Thanks in advance!

Chris Lucas · January 19, 2011, 07:46

Hi,

OpenFoam has tools to calculate the Mach number afterwards. The command might be "Mach". Have a look under utilities/postProcessing.

Regards,
Christian

January 19, 2011, 04:28	How to visualise the mach number and pressure coefficient in ParaView	#1
xck1986 Member chenkai Join Date: May 2010 Location: munich Posts: 44 Rep Power: 15	Hello Foamuser, I am now using rhoSimpleFoam to simulate the ONERA M6 WING in OpenFOAM. And I have a question about how to get the mach number and pressure coefficient in ParaView. Do I also need to set the initial and boundary condition for the Machnumber in the 0 folder? Thanks in advance!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Simulation of a single bubble with a VOF-method	Suzzn	CFX	21	January 29, 2018 00:58
Constant velocity of the material	Sas	CFX	15	July 13, 2010 08:56
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05
air bubble is disappear increasing time using vof	xujjun	CFX	9	June 9, 2009 07:59
Automotive test case	vinz	OpenFOAM Running, Solving & CFD	98	October 27, 2008 08:43

January 19, 2011, 07:46		#2
Chris Lucas Senior Member Christian Lucas Join Date: Aug 2009 Location: Braunschweig, Germany Posts: 202 Rep Power: 17	Hi, OpenFoam has tools to calculate the Mach number afterwards. The command might be "Mach". Have a look under utilities/postProcessing. Regards, Christian