Hi guys!
I tried to expand the domain in order to ensure flat surface (so you know that the height is zero). But I was not able to create a mesh. I constantly got the same error message as I posted. Only when I used Ben’s original domain and adjusted the z-directions it was OK. I “hope” the stl-file is bad outside the domain Ben suggested otherwise I do not understand why this did not work. Anyway – I have run the case and it work fine. I used simpleFoam (right now I did not make it work on simpleWindFoam. But my Bolund case (without turbines) work fine at both simpleFoam and simpleWindFoam and they looks similar). Ben – are you still on this case? I’m very interested in helping you since I’m learning a lot doing so. It is good to compare Bolund and Askervein. Are you two also working with turbines? siri |
Hi,friend, i am also use simplewindfoam.can you tell me how to delete the turbines in the case?If it is possible,please tell me in detail.Thanks a lot .
|
Hi,snoppsnuske,i have a question,that is the terrain in the OpenFOAM1.7.1....../simpleWindFoam/turbinesiting is Askervein or Bolund? And how to translate the format of .xyz to the format of .stl? Thank you very much.
|
Hi Guys,
I am planning on doing a project related to the Askervein Hill over the next few months as a part of my Masters. Thing is, I can't get hold of a .stl file of the hill. I have a limited amount of time to get the results and I would prefer to spend the time trying to get my RANS/LES hybrid model to work. Any chance I could use the a .stl file one of you guys have used. It goes without saying it will be properly attributed and referenced. Many Thanks, Toby Collinson University of Exeter. |
Hello,
did you manage to find this STL file? I have found a small cloud of points in this web site: http://code.google.com/p/fds-smv/sou...DS_Input_Files which one can convert to an STL using surf2stl.m or stlwrite under Matlab. But I am not sure if this the whole hill I am seeing there. The domain seems a bit coarse (129x129 points grid), and it looks smaller than what I usually see in theses/reports. I would be very grateful if you could point me to another source where to get an STL of the hill! Regards, Carlos |
you can use globalmapper to get stl file.
|
thanks for the suggestion, but unfortunately I do not have
access to any non-open source software :-(. |
Hello everybody,,
i am also new to OpenFOAM...and i am doing ABL simulations for wind turbines......i have read all posts over here....and i think all you guys would have completed your thesis.....i have started my thesis and its my 5th week....its really hard to get some information for my doubts....please send me any material to my mail..if you guys are active..then i can post my doubts over here.....prakashqd@gmail.com |
.xyz file in askervien
helly guys..
I have been trying to find a .xyz file of the askervein and bollund hill.. but in vain.. can anybody help me? Cheers Zay |
All times are GMT -4. The time now is 05:29. |