[stawrogin]

Dear all,

I actually have a CHT problem (OF 1.7) where I couple several solid regions with quite different thermal conductivity (there are also some fluid regions as well)
I have some convergence problems in the solid regions and I wonder if this might be caused by the patch type at the solid-solid interfaces.
I use the same interfaces for T at the solid/solid and solid/fluid side:

compressible::turbulentTemperatureCoupledBaffleMix ed

{
type compressible::turbulentTemperatureCoupledBaffleMix ed;
neighbourFieldName T;
K K;
value uniform 300;
}

I wonder if there is a better patch for solid/solid coupling. But using K -> K should be okay I think.

Any suggestions?

Thanks a lot
Stawrogin