CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM (http://www.cfd-online.com/Forums/openfoam/)
-   -   Rename part of a boundary patch (http://www.cfd-online.com/Forums/openfoam/90282-rename-part-boundary-patch.html)

Arnoldinho July 6, 2011 08:21

Rename part of a boundary patch
 
Hi all,

I'm nut sure if (but hope that) there is a utility to do the following: I have a mesh with boundary patches, e.g. with bottom at the lower boundary, and I afterwards want to rename a part of the bottom batch to bottom2.
So something like a cellSet (giving coordinates) to look for boundary patch faces, rename part of the boundary patch to boundary2 and update all variables in the constant/polymesh dir.

Is there something like that?

Arne

Arnoldinho October 28, 2011 11:02

I want to push this up again...

Phicau October 28, 2011 11:42

Sure, check this out:

http://www.cfd-online.com/Forums/ope...-surfaces.html

Arnoldinho October 29, 2011 05:53

Thanks, that's what I was looking for! Works.


All times are GMT -4. The time now is 09:45.