Modelling of Headlamp Condensation

nkjsimulating · July 14, 2013, 05:05

Hi Foamers

I want to develop Computational Fluid Dynamics (CFD) methodology in OpenFoam that will predict the condensation formation in an automotive headlamp.

As far as preprocessing is concerned0, I can generate desired mesh file in ANSA but quite confused with the BCs and selection of solvers.

can anyone guide me ??

Thnks

mbay101 · July 17, 2013, 04:32

Hallo nkjsimulating,
just so you know. Every Company do her own Simulation. If you are planning on simulat only the headlamp you should take a look in the Company website. for example Osram.

Can u tell me in which stage you are with the Simulation?

Best wishes

nkjsimulating · July 18, 2013, 15:39

thnks for your valuable suggestion.

I am figuring out the best method to solve my physical problem with OpenFoam..I have read couple of NAFEMS benchmark for this..and looking forward to set up my problem.

July 14, 2013, 05:05	Modelling of Headlamp Condensation	#1
nkjsimulating New Member Niraj Join Date: Jul 2013 Location: Germany Posts: 15 Rep Power: 12	Hi Foamers I want to develop Computational Fluid Dynamics (CFD) methodology in OpenFoam that will predict the condensation formation in an automotive headlamp. As far as preprocessing is concerned0, I can generate desired mesh file in ANSA but quite confused with the BCs and selection of solvers. can anyone guide me ?? Thnks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
error message	cuteapathy	CFX	14	March 20, 2012 06:45
combustion radiation and condensation in cfx	siden	CFX	1	February 3, 2011 17:39
Advice on multi-phase flow modelling	Martin	Main CFD Forum	3	October 14, 2008 05:16
condensation of water vapour at room walls	Felix	FLUENT	0	September 14, 2007 11:03
Help modelling condensation	STK	FLUENT	0	October 27, 2004 11:07

July 17, 2013, 04:32		#2
mbay101 New Member M Bay Join Date: Jun 2013 Location: Germany Posts: 10 Rep Power: 12	Hallo nkjsimulating, just so you know. Every Company do her own Simulation. If you are planning on simulat only the headlamp you should take a look in the Company website. for example Osram. Can u tell me in which stage you are with the Simulation? Best wishes

July 18, 2013, 15:39		#3
nkjsimulating New Member Niraj Join Date: Jul 2013 Location: Germany Posts: 15 Rep Power: 12	thnks for your valuable suggestion. I am figuring out the best method to solve my physical problem with OpenFoam..I have read couple of NAFEMS benchmark for this..and looking forward to set up my problem.