|September 16, 2011, 06:48||
Problem editing files when running in parallel
Join Date: May 2010
Posts: 38Rep Power: 6
When I run a case in parallel to time xx and the try to open the processorx/xx/U file the internalField values are not translated correctly (using cat,nano,vim) or character coding cannot be detected (in gedit).
And if I try to edit the "healthy" part of the file, something goes wrong.
This is not happening when i run in serial mode.
I need to be able to edit these files to change e.g. inlet velocity after some time (?)
|Thread||Thread Starter||Forum||Replies||Last Post|
|Parallel Run problem||shhe||OpenFOAM Running, Solving & CFD||1||April 27, 2010 06:52|
|Problems in compiling paraview in Suse 10.3 platform||chiven||OpenFOAM Installation||3||December 1, 2009 07:21|
|Statically Compiling OpenFOAM Issues||herzfeldd||OpenFOAM Installation||21||January 6, 2009 09:38|
|Kubuntu uses dash breaks All scripts in tutorials||platopus||OpenFOAM Bugs||8||April 15, 2008 07:52|
|parallel mode - small problem?||co2||FLUENT||2||June 1, 2004 23:47|