 |
 |
 |
|
|
|
[Sponsors] | ||||
October 6, 2011, 14:42
|
Rescaling result data
|
#1 |
|
New Member
Ivan
Join Date: May 2011
Posts: 2
Rep Power: 0  |
I have done a simulation but realized my mesh was too big (my dimensions were 10^3 times greater) I have a lot of data and I am trying to avoid rerunning the whole thing with the rescaled mesh using the transformPoints command. Does anyone know if my data can be rescaled? Any help would be greatly appreciated.
|
|
|
|
|
|
October 6, 2011, 15:42
|
|
#2 |
|
Senior Member
Bernhard
Join Date: Sep 2009
Location: Delft
Posts: 790
Rep Power: 21 |
If your mesh is identical, except for the dimensions, I suppose you can just copy the files to the 0/ folder? However, the results will not make sense any longer.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| export data at nodes | Meenu | FLUENT | 1 | December 30, 2011 01:24 |
| Trying to Output Data from *Specific Zone* (e.g. axis of symmetry) Within 2D Domain | ksiegs2 | FLUENT | 1 | February 27, 2011 14:54 |
| Data import in Fluent?! | Bart Horsten | FLUENT | 3 | February 22, 2010 13:05 |
| XYZ (ASCII format) data points into GAMBIT | Neil | FLUENT | 1 | August 7, 2007 09:24 |
| CFXSolver Error Message using Profile Data on B | Tobias | CFX | 0 | August 26, 2005 07:27 |
Linear Mode
