|
[Sponsors] |
October 12, 2011, 15:36 |
cyclic boundaries not identical
|
#1 |
Member
Adam
Join Date: Jun 2011
Posts: 32
Rep Power: 14 |
I have two plates which use the cyclic boundary condition in OpenFOAM 2.0.1, and at any given timestep, the solution on each of these boundaries is not identical. I'm wondering why this is the case.
Does the cyclic BC utilize ghost cells which could cause this to happen? Could it be because these plates are not parallel? Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Parallel refineMesh with Cyclic Boundaries | mchurchf | OpenFOAM | 8 | December 22, 2018 11:11 |
Problem with cyclic boundaries in Openfoam 1.5 | fs82 | OpenFOAM | 36 | January 7, 2015 00:31 |
Problems with cyclic boundaries in faMeshDefinition and surfactantFoam | safre | OpenFOAM | 3 | December 12, 2011 07:56 |
error in cyclic boundaries match | Steve | Siemens | 2 | March 4, 2008 04:32 |
Cyclic Boundaries -> Match Option -> Arbitrary | Derek | Siemens | 1 | August 4, 2004 22:06 |