|
[Sponsors] |
August 3, 2012, 04:31 |
Surface Flow Filter
|
#1 |
New Member
Join Date: Mar 2012
Posts: 1
Rep Power: 0 |
Hello everybody
I have a question about the surface flow filter: If i have a surface with Backflow... how do the filter deal with that? If the Backflow and the Forward Flow have the same value... is the Flowrate zero??? If the answer is yes, is it possible to show the forward and backward flow separated? to my problem: i have a mixing tank and i want to find out the circulation rate of the fluid. thanks for your attention g MCCourant |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[General] Mass Flow Using Surface Flow Filter Incorrect | t8fanning | ParaView | 1 | March 13, 2017 05:56 |
[OpenFOAM] How to calculate the fluid flow through a surface | lynx | ParaView | 4 | January 20, 2016 11:58 |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
[swak4Foam] funkyDoCalc mass flow over stl surface? | lourencosm | OpenFOAM Community Contributions | 0 | November 28, 2014 07:50 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |