CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ParaView (http://www.cfd-online.com/Forums/paraview/)
-   -   Slicing with .stl surface (http://www.cfd-online.com/Forums/paraview/107337-slicing-stl-surface.html)

Lance September 24, 2012 11:32

Slicing with .stl surface
 
Hi,
Is it possible to slice an unstructured grid with a .stl surface imported into paraview? The .stl surface is 3D and very complex and cannot be approximated with a plane or box or anything else. Any suggestions are appreciated!

MarkHerskind October 23, 2014 08:49

Did you make any progress on this?

I have a similar problem, so I would be very interested in your solution..


All times are GMT -4. The time now is 11:13.