 |
 |
 |
|
|
|
[Sponsors] | ||||
[General] How to display the chamber wall surface in light color when 3D contours are plotted ? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 2, 2012, 18:36
|
How to display the chamber wall surface in light color when 3D contours are plotted ?
|
#1 |
|
Senior Member
Join Date: Nov 2012
Posts: 171
Rep Power: 13  |
Hi All,
I am using paraview to visualize the contous of the flow in a chamber. However, I do not know how to make the wall surface (not only the lines) displayed in a very light color (e.g. gray) in the figure. I know tecplot can do this. Is there anybody who can give me some hints about this issues? Thank you very much. best regards, hz |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| surface heat transfer coeff of wall flux | rsa | FLUENT | 0 | June 1, 2016 09:40 |
| [Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
| [snappyHexMesh] Problem with snappyhexMesh: modelling a pore chamber and pore throat model | Saideep | OpenFOAM Meshing & Mesh Conversion | 5 | May 10, 2015 14:46 |
| free surface display | carno | Siemens | 4 | October 7, 2005 01:03 |
| Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |
Linear Mode
