Streamlines of polyhedral meshes
 

Hi there!

Does anyone have some experience regarding polyhedral meshes in paraview ?
I tried to generate Streamlines an it doesn´t work.
Paraview crops them after a couple of mm.

I`m using v3.98.1 64-bit

Thank you very much.
Cheers
Dito

Greetings Dito,

There was another thread with a similar topic sometime ago... here we go: http://www.cfd-online.com/Forums/ope...-paraview.html

Er, wait... on that the thread the problem was actually that the mesh was not in polyhedral form and it worked fine and it was in polyhedral form.

Are you certain that your mesh is in polyhedral form?

Best regards,
Bruno